2014 GMC Acadia
Mileage
83,859
Service Date
11/19/2024
Services Performed
- CUSTOMER REQUEST TO CHECK MOTOR/ENGINE MOUNTS AND A/C PERFORMANCE
- THE TECHNICIAN WILL LOAD TEST THE BATTERY, TEST THE STARTER FOR AMPERAGE DRAW AND IF POSSIBLE, LOAD TEST THE ALTERNATOR. NOTE IF ANY TEST FAILS AND PROVIDE ESTIMATE FOR REPAIRS. INSPECTION FEE WILL BE APPLIED TO THE REPAIR UPON APPROVAL IN THE SAME VISIT.
- ADVISE ON PARKING BRAKE ADJUSTMENT
- Remove existing Cabin Filter and with blower fan running off external air, introduce Frigi Fresh to vent intake near hood. The Frigi Fresh will deodorize the fan box and all the under dash vents leaving them smelling fresh and clean. Once performed the new filter is installed and checked for proper operation.
- DRAIN AND FILL ENGINE OIL, REPLACE ENGINE OIL FILTER, INSPECT BRAKES (THRU THE WHEELS, IF POSSIBLE), CHECK AND TOP OFF ALL FLUIDS EXCEPT FUEL.
- PERFORM A TOTAL QUALITY INSPECTION ON VEHICLE. A 4O+ POINT DIGITAL INSPECTION WITH PICTURES AND VIDEOS WILL BE TEXT (OR EMAIL IF YOU PREFER) TO YOU. LOOK OVER THAT INSPECTION AND THEN CALL US AT 951-677-2373
- RESET MAINTENANCE LIGHT AND PRINT REMINDER STICKER
- REMOVE BATTERY FROM VEHICLE AND VERIFY SIZE. COMPARE NEW BATTERY TO EXISTING AND ENSURE PROPER FITMENT. PERFORM LOAD TEST ON NEW BATTERY, VERIFY PROPER OPERATION.
- CA BATTERY FEE
- Take pictures of the p/s pressure hose,frt struts and control arms bushings.
- POWER STEERING HOSE – Remove & Replace – FWD Pressure,Pump to Steering Gear – [Includes: R&I Catalytic Converter.] – [Includes: Bleed System.]
- PARKING BRAKE SHOE & LINING – Remove & Replace – Both – [Includes: Replace Rear Disc Brake Pads (if necessary) and clean, lube and/or replace Parking Brake Hardware (as necessary). DOES NOT include refinishing.]
- CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
- TEST DRIVE VEHICLE TO CONFIRM ANY PULLING OR IF THE STEERING WHEEL IS OFF-CENTER. SHAKE DOWN FRONT AND REAR SUSPENSION CHECKING FOR ANY WORN COMPONENTS THAT COULD EFFECT THE ALIGNMENT. PERFORM ALIGNMENT USING HUNTER LASER ALIGNMENT MACHINE. ADJUST ALL FACTORY ADJUSTABLE ANGLES TO THE MIDDLE OF FACTORY SPECIFICATIONS. NOTE IF ANY ANGLE IS STILL OUT OF ADJUSTMENT, IF AN ADJUSTMENT IS MAXED OUT, IF PARTS NEED REPLACEMENT OR IF A CAMBER KIT NEEDS INSTALLED. VERIFY PROPER OPERATION WITH A STRAIGHT STEERING WHEEL WITH A FINAL TEST DRIVE. SEE ATTACHED BEFORE AND AFTER MEASUREMENTS.
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Trans,Rear,Left Side of Engine Compartment
- AUTHORIZATION # 339895235
John C. gave our service a 5 star review on 11/20/2024
